TROUBLESHOOTINGOur thoughtful approach extends to our support before and after your purchase. Electrolux Oxygen Central VacuumIf you experience a problem with your central vacuum system, follow the troubleshooting suggestions below before calling for service.
Partial/Total Loss of Suction Power - Be sure dirt receptacle is on properly.
- Empty dirt receptacle.
- Remove debris from filter.
- Be sure each inlet valve is properly closed.
Blockage in Pipes or Hose
Plug hose into any inlet valve. If there is no suction through the hose after connecting at a couple of inlets, the blockage is in the hose. To clear the hose obstruction, insert a blunt instrument into the hose (garden hose, wood dowel). You can also attempt to reverse the suction through the hose to dislodge the blockage. If there is one inlet valve without normal suction and you have checked for hose blockage, then the blockage is in the pipe system between the blocked inlet valve and the power unit. Insert the hose into the inlet valve where there is no suction; hold your hand over the hose end. Release hand quickly. Repeat several times. If blockage does not clear, contact your nearest dealer/distributor. Power Unit Will Not Start
Check for blown fuse or circuit breaker in main house electric supply box. Unplug and check all wall inlet and low voltage connections for loose wires. If unit still will not start, contact your nearest authorized service representative. Power unit will not stop
Check inside each inlet valve for obstruction of low-voltage contacts. If no visual obstruction can be detected, disconnect the cleaner from the power receptacle and contact your nearest service station/dealer. Central Power Unit shuts Off By Itself
Remove and then re-insert hose into inlet or toggle switch off-on located on hose handle. See “Overload Protection”. Overload Protection
The central vacuum system employs features that monitor the following operating levels: AC voltage, and current draw. If the voltage is below or above standard operating voltage, high current draw or locked rotor, the power unit will not operate. In this case the On/Off button will blink until the problem ceases or on the LCD model the screen will flash. If problems persist; contact your authorized service representative. The power unit requires 30 minutes to cool down. Electrolux Oxygen Air PurifierBefore you call for service, review the list below. This list covers problems that are not the result of defective materials or workmanship. The remote control does not work
Make sure the remote control battery is inserted correctly. Replace worn-out battery. The unit leaves smoke and odors in the air
Make sure the sensor is not blocked or clogged. Move the unit closer to the offending odors. Replace the filters as needed. The unit seems to produce odors.
Replace the filters as needed. The odor light is blue, but there is still odor in the air.
Clean the sensor with a vacuum cleaner, as it may be blocked or clogged. The odor light is on high, but the air seems clean.
Clean the sensor with a vacuum cleaner, as it may be blocked or clogged. The light is orange or red on the dust sensor, but the air seems clean.
Clean the dust sensor with a vacuum cleaner, as it may be blocked or clogged. Unit interferes with radio or television reception.
Because this unit radiates radio frequency energy, we suggest you try one or more of the following: - For better reception, adjust the television/radio antenna.
- Move the unit away from the affected television/radio.
- Plug the unit power cord into an outlet different from the television/radio power cord.
The FILTER indicator remains lit after replacing the filter.
Press the Filter Reset button by inserting a paper-clip into the Reset button hole. Hold for 3-5 seconds for a beep to sound to indicate the unit has been reset.
|
